AGC gain index only reads while LNA or mixer is in AGC — register 0x03 returns a flat 0xff in manual mode, which means no reading, not "gain is maxed". A loop sitting at its minimum is the front end telling you it has run out of room.
LNA and mixer sit ahead of the IF filter and are where a strong signal compresses; the VGA sits after it. Backing the first two off and raising the VGA buys headroom at the cost of noise figure — the trade a single dB number can't express.
Changing a stage here puts the radio in Pro gain, which turns off the VGA loop that keeps the ADC out of clipping. It is saved, and the main UI shows it. Back to Auto hands gain back to the radio.
Everything inside this filter reaches the VGA and ADC — including the parts the DSP later throws away — and eats ADC headroom. Narrowing it keeps a strong neighbour out before it costs bits. It sits after the LNA and mixer, so it cannot help them.
Auto gain picks this itself, so changing it here puts the radio in Pro (Manual and Pro keep their tier). It is saved. It also narrows what the IQ stream contains: a panorama scan or a waterfall wider than the filter sees its skirts instead of the band. Set it back to ~6 MHz before scanning.
This is the only filtering ahead of the LNA, so it is the only control that can reject an out-of-band interferer before it compresses the front end. The IF filter is downstream of the damage; this is upstream of it.
It is genuinely coarse — the band table steps about per octave, so across the whole FM dial only two settings are ever picked automatically: 0x34, then 0x24 above ~106.5 MHz. Overriding tf_c by hand is how you get anything finer. The override is re-applied on every retune, so it sticks until you clear it.
There is no signal-level readout built into this page — the server does not broadcast one — so judge the effect by ear, or on the waterfall in the main UI. Band boundaries also shift with the IF filter: at 3.57 MHz the step is at 106.5 MHz, at 2.121 MHz it moves to 107.9 MHz.
Where each loop aims, rather than overriding it — so the AGC keeps its range on weak signals while backing off harder on strong ones. Tolerance is the detector voltage a stage puts up with before it starts pulling gain down; recover is the level it has to fall below before gain comes back. Take-off is the same idea as a coarse step (higher number = backs off sooner), and release rate is how fast the detector discharges. Only meaningful for stages left on AGC.
Wiped by re-init on reconnect or server restart. Move one at a time.
The digital AGC acts on the ADC output — downstream of both the tuner and the ADC — so it can't rescue a front end that is already clipping. It only makes the most of whatever got through.
| Reg | Hex | Bits |
|---|---|---|
| — | ||
0x0D and 0x0E set the voltage thresholds the LNA and mixer AGC power detectors trip at — how strong a signal has to be before those loops start backing off. 0x1E bits [5:0] control the channel filter extension. Hex (0x..) or decimal both work.
ready